How should the FastEthernet0/1 ports on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices?

Rate this post

QUESTION 41

Refer to the exhibit.

How should the FastEthernet0/1 ports on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices?

20

A. The ports only need to be connected by a crossover cable.

B. SwitchX(config)# interface fastethernet 0/1

     SwitchX(config-if)# switchport mode trunk

C. SwitchX(config)# interface fastethernet 0/1

     SwitchX(config-it)#switchport mode access

      SwitchX(config-it)#switchport access vlan 1

D. SwitchX(config)#interface fastethernet 0/1

     SwitchX(config-if)#switchport mode trunk

     SwitchX(config-it)#switchport trunk vlan 1

     SwitchX(config-if)#switchport trunk vlan 10

     SwitchX(config-it)#switchport trunk vlan 20

Correct Answer: B

Section: VLAN

Explanation

Explanation/Reference: