Chuyên mục: CCNA v5.02(LAB)

CCNA NAT SIM Question 1

Question You are tasked to configure Internet access on a router. The ISP has provided the company six public IP addresses of 198.18.184.105 198.18.184.110. The company has 14 hosts that need to access the internet simultaneously. The hosts in the company LAN have been assigned private space addresses in the range of 192.168.100.17 – 192.168.100.30. […]

Read More

CCNA Configuration SIM Question

Question Refer to the topology TUT Company recently installed a new router in their office. Complete the network installation by performing the initial router configurations and configuring RIPv2 routing using the router command line interface (CLI) on the R2-TUT. Name of the router is R2-TUT Enable-secret password is Sec@ret The password to access user EXEC mode using […]

Read More

CCNA NAT SIM Question 2

Question You work as a network technician at 9tut.com. Study the exhibit carefully. You are required to perform configurations to enable Internet access. The Router ISP has given you six public IP addresses in the 198.18.32.65 198.18.32.70/29 range. 9tut.com has 62 clients that needs to have simultaneous internet access. These local hosts use private IP […]

Read More

CCNA VTP SIM Question

Refer to the topology below, you are only allowed to access the CLI of Sw-AC3 to answer some questions. This does not require any configuration. Question 1 What interface did Sw-AC3 associate with source MAC address 0010.5a0c.ffba ? a) Fa0/1 b) Fa0/3 c) Fa0/6 d) Fa0/8 e) Fa0/9 f) Fa0/12 Answer: Fa 0/8 Explanation To find […]

Read More

OSPF Neighbor Sim

Question The topology below is running OSPF. You are required to troubleshoot and resolve the OSPF issues between the various routers. Use the appropriate show commands to troubleshoot the issues. Instead of posting the output of “show run” commands we post here the commands entered on each router to reduce some useless lines. Also you […]

Read More

EIGRP Troubleshooting Sim

EIGRP Troubleshooting Sim Question The topology below is running EIGRP. You are required to troubleshoot and resolve the EIGRP issues between the various routers. Use the appropriate show commands to troubleshoot the issues. Instead of posting the output of “show run” commands we post here the commands entered on each router to reduce some useless […]

Read More

CCNA Access List Sim 2

QUESTION 256 A corporation wants to add security to its network. The requirements are: -Host C should be able to use a web browser(HTTP)to access the Finance Web Server -Other types of access from host C to the Finance Web Server should be blocked. –All acces from hosts in the Core or local LAN to […]

Read More

CCNA Access List Sim

Question An administrator is trying to ping and telnet from Switch to Router with the results shown below: For this question we only need to use the show running-config command to answer all the questions below: Router>enable Router#show running-config Question 1 How can we fix the problem but only allow ping to work while disabling […]

Read More

CCNA EIGRP Lab

QUESTION 254 EIGRP Simulation After adding Interior router, no routing updates are being exchanged between Perimeter and the new location. All other inter connectivity and Internet access for the existing locations of the company are working properly The Task is to identify the fault(s) and correct the router configurations to provide full connectivity between the […]

Read More